Announcement

Collapse
No announcement yet.

Relay not disconnects two wires

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Relay not disconnects two wires

    Hi,

    I'm testing UltraGCIR plugin on HS3 with GC-100-12, I'm trying to use the relay on the GC to turn on and off wired alarm sensors, if I disconnect the wires by hand the sensor turn off but if I'm using the relay port on the GC-100 and sending active/inactive command with HS3 plugin it's not working. Anyone can help here? How do I use the relay port with plugin so I can turn on or off wired sensors?

    Regards,
    hadyos

    #2
    Are you seeing the relay light go on/off?

    Regards,
    Ultrajones
    Plug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR

    Comment


      #3
      Yes, even if I pull the little gray plug out of the gc-100 the sensors go off but not with the plugin.

      hadyos

      Comment

      Working...
      X