All the devices from my thermostat appears to be in HS Touch designer except operating status(cooling or standby). Any idea why. Also on one of my HS Touch screens I want to put set-point value. In HS Touch designer I can chose cooling set-point or heating set-point. Any for set-point being displayed would based on whether system mode is in heating or cooling?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.