I have several of these Leviton two button controllers and until recently I thought they worked like every other Z wave switch I have (that is, the button controls the appliance load). However when I connected these to a Vera Edge I noticed that the Vera added a two button scene controller and two separate appliance modules. This was handy because I could have the buttons turn on/off Hue or LIFX bulbs WITHOUT turning off power to the circuit. I still had access to the appliance module to turn it off if I needed to reset a bulb or whatever and seemed far superior to hard wiring a circuit on. Any idea if HS3 has the same behavior? I won't have the time to test it out myself for a while but I may end up ordering a few more of these switches as they make dealing with LIFX/Hue bulbs much easier! Thanks!
Sean
Sean
Comment