How to update non-listening devices?

[rsisson]

I have several zooz 4-in-1 device.

Overall I love them.

However, I want to "adjust" some of them.

I want to change some of the Parameters, like desensitize the Motion a bit on one.

Is there a way to do that without climbing the ladder, taking the sensor down, taking it to my controller, waking it up, changing the parameter, and then climbing the ladder and putting it back?

I.E., is there a way to "queue" a parameter update so the next time it wakes up for whatever reason (motion, battery, or temperature update) that the update gets pushed out.
I would love to queue the change, go through the room (motion) and force the update, and then see how it behaves rather than using the Zwave button on each device....

[sparkman]

For devices that support the Wake-up Command Class, parameter changes do get queued, but typically they only wake up and listen to those types of messages during the official Wakeup period, not when they wake up to send status updates. If they can talk to the controller from where they are currently located, you can wake them up in place and use a phone/tablet to do the parameter change from the ladder, rather than taking it down, bringing it over to the controller, etc.

Cheers
Al

[ykamenet]

Could use some help with making these sensors work please

sparkman - can I ask you a question? How did you get your Zooz 4-in-1 sensor to work well? I ordered a bunch of them from Monorpice, I think they are all basically rebadged Vision Security ZP3111 sensors. And I added two of them and having very inconsistent results. Motion does not register well and battery is always "0". Humidity, Luminance, and Temperature are not updating consistently either. Did you have to do any additional configuration or set any parameters? Would appreciate your assistance. Thanks.

[sparkman]

sparkman - can I ask you a question? How did you get your Zooz 4-in-1 sensor to work well? I ordered a bunch of them from Monorpice, I think they are all basically rebadged Vision Security ZP3111 sensors. And I added two of them and having very inconsistent results. Motion does not register well and battery is always "0". Humidity, Luminance, and Temperature are not updating consistently either. Did you have to do any additional configuration or set any parameters? Would appreciate your assistance. Thanks.

Sorry, I don't have any Zooz sensors, but have other brands of similar sensors.


Sent from my Phone using Tapatalk