I have the following setup:
* DSC PC1864 with several 5108 extension modules
* PC1864 is connected via PC-Link to my HS computer
* IT-100 connected to PC1864 and my HS computer via a straight-through serial cable.
With the above setup I was finally able to get some status from the different zones. "Partition-1" changes from "Trouble Status" (mostly) to "Partition Not Ready" (for less than a second) and back again. Two zones show as "Zone Opened" but all others show up as "Zone Restored". None of the zones are updating, even as I open and close doors (Last changes is also stuck despite the fact that I configured it to update every 10 seconds). So something is still not working but I can't figure out what. Any input/tutorial/etc would be appreciated. Note that all sensors have resistors at the panel but some might also have resistors at the doors (probably not but our installer might have done so) and others don't (the interior doors that I wired and where I really don't need resistors at the door).
* DSC PC1864 with several 5108 extension modules
* PC1864 is connected via PC-Link to my HS computer
* IT-100 connected to PC1864 and my HS computer via a straight-through serial cable.
With the above setup I was finally able to get some status from the different zones. "Partition-1" changes from "Trouble Status" (mostly) to "Partition Not Ready" (for less than a second) and back again. Two zones show as "Zone Opened" but all others show up as "Zone Restored". None of the zones are updating, even as I open and close doors (Last changes is also stuck despite the fact that I configured it to update every 10 seconds). So something is still not working but I can't figure out what. Any input/tutorial/etc would be appreciated. Note that all sensors have resistors at the panel but some might also have resistors at the doors (probably not but our installer might have done so) and others don't (the interior doors that I wired and where I really don't need resistors at the door).