Good Morning,
I'm having an issue as I work to add several door sensors. For all my other Insteon devices I've used the plugin's "Tap Add" feature and that's worked well. However after trying this with three separate sensors I decided that tap add will not work (sensor in inclusion mode).
I've had some more success with inputting in ID and adding this way. That seems to work however when I try the "Program device for Homeseer" that consistently fails (even after getting the double beep from the sensor itself). I have however been able to complete a "Reprogram device" consistently.
I now see the Device, Heartbeat, battery level and low battery children. When the device is awake I can communicate with it as well. The only issue is that the sensor will never change state. It has shown as "Closed" since I added it and I'm unable to change the state. This is after adding three separate sensors with all the same behavior. All three devices have a firmware rev of 45.
I'm having an issue as I work to add several door sensors. For all my other Insteon devices I've used the plugin's "Tap Add" feature and that's worked well. However after trying this with three separate sensors I decided that tap add will not work (sensor in inclusion mode).
I've had some more success with inputting in ID and adding this way. That seems to work however when I try the "Program device for Homeseer" that consistently fails (even after getting the double beep from the sensor itself). I have however been able to complete a "Reprogram device" consistently.
I now see the Device, Heartbeat, battery level and low battery children. When the device is awake I can communicate with it as well. The only issue is that the sensor will never change state. It has shown as "Closed" since I added it and I'm unable to change the state. This is after adding three separate sensors with all the same behavior. All three devices have a firmware rev of 45.
Comment