Wife set off alarm accidentally this morning... turned it off from Panel.
still flashing in HS3 device from "Disarmed-ready" to "faulted".
any advice on how to clear the fault? can't find it anywhere.
EDIT: as a side note, my panel does not say faulted.... but i think i may misunderstand this.
I just noticed that if my motion detector sees me, it shows faulted in the device... even when the alarm is disarmed. if that's the case, then it's working correctly.
My problem is that i just created an event that texts me if there is a fault (to me... meaning the alarm went off)... and i keep getting texts.
Guessing i need the trigger to be burglar alarm and not fault.
still flashing in HS3 device from "Disarmed-ready" to "faulted".
any advice on how to clear the fault? can't find it anywhere.
EDIT: as a side note, my panel does not say faulted.... but i think i may misunderstand this.
I just noticed that if my motion detector sees me, it shows faulted in the device... even when the alarm is disarmed. if that's the case, then it's working correctly.
My problem is that i just created an event that texts me if there is a fault (to me... meaning the alarm went off)... and i keep getting texts.
Guessing i need the trigger to be burglar alarm and not fault.
Comment