I just installed a Z-Wave mag door contact set.
I added the node with the device in near proximity of my Z-Troller. Added OK.
Next, I mounted the mag contact in its final location which is within 10 feet of a Z-Wave strobe/siren unit and 15 feet line of sight to a Z-Wave thermostat.
I opened the door to "wake up" the unit then did a full network optimize.
Z-Seer shows that the node is still trying to connect all the way back to the Z-Troller, which is out of range. Also, the new node does not show up in a full network optimize.
Can anyone throw me a clue on how to get this node connected to it's nearest neighbor?
Many thanks.
I added the node with the device in near proximity of my Z-Troller. Added OK.
Next, I mounted the mag contact in its final location which is within 10 feet of a Z-Wave strobe/siren unit and 15 feet line of sight to a Z-Wave thermostat.
I opened the door to "wake up" the unit then did a full network optimize.
Z-Seer shows that the node is still trying to connect all the way back to the Z-Troller, which is out of range. Also, the new node does not show up in a full network optimize.
Can anyone throw me a clue on how to get this node connected to it's nearest neighbor?
Many thanks.
Comment