Hi
Relatively new to Homeseer and the Audrino plug-in. Thanks to this forum I've solved 9 of my 10 issues through research. Fantastic system having used Vera before.
However stumped with fixing this.
Requirement:
- Have Audrino auto re-connect when either USB connection lost or PC reboots
- Need to have system operating close to 24/7 without intervention (WAF)
Observations:
1) Pulling USB plug out, Audrino plug-in still shows "Connected" with "Warning = Com Port No:4 is not open"
2) Putting USB back in, plug-in does not restore connections, despite showing "connected"
3) Manually disconnecting and connecting sometimes work, but often get "Error = Exception in Connect : Access to the port 'COM4' is denied"
4) Unchecking and checking "Auto Connect" sometimes works
5) With PC restart, connection re-established automatically 80% of the time
6) Manually killing the service "HSPI_Arduino (32)" (Arduino IDE) seems to unlock access to the com port and everything works fine again
Setup:
- Arduino Mega 2560
- Arduino Plugin V1.0.0.147
- Arduino IDE 1.8.1
Debug file attached.
Any help or advice to a novice appreciated.
Thanks!
Relatively new to Homeseer and the Audrino plug-in. Thanks to this forum I've solved 9 of my 10 issues through research. Fantastic system having used Vera before.
However stumped with fixing this.
Requirement:
- Have Audrino auto re-connect when either USB connection lost or PC reboots
- Need to have system operating close to 24/7 without intervention (WAF)
Observations:
1) Pulling USB plug out, Audrino plug-in still shows "Connected" with "Warning = Com Port No:4 is not open"
2) Putting USB back in, plug-in does not restore connections, despite showing "connected"
3) Manually disconnecting and connecting sometimes work, but often get "Error = Exception in Connect : Access to the port 'COM4' is denied"
4) Unchecking and checking "Auto Connect" sometimes works
5) With PC restart, connection re-established automatically 80% of the time
6) Manually killing the service "HSPI_Arduino (32)" (Arduino IDE) seems to unlock access to the com port and everything works fine again
Setup:
- Arduino Mega 2560
- Arduino Plugin V1.0.0.147
- Arduino IDE 1.8.1
Debug file attached.
Any help or advice to a novice appreciated.
Thanks!
Comment