I received the http://bit.ly/2o7D5WC both in single and double switch. They added fine with just one device shown. The double switch shows 1002 and 2002. I don't see any possibility of double clicks.
I also received http://bit.ly/2EQvVPM which gives a value of 1002 and shows "Pressed one time". If I quick press twice, the message goes blank but the value still remains at 1002 as far as I can tell.
Lastly I received http://bit.ly/2C4URlK door sensors. Very nice but only stick-on, although they're so light I'm sure they'll stay put even on wood frames. All the devices are instant response so creating events to z-wave devices was a piece of cake.
They all paired with the Raspbee and of course showed up immediately in HS3. I do wish there were some english instructions that would point out how long to hold a button for pairing and how long to hold a button for reset. I have yet to see this online.
Does anyone have the Aqara hub to see if things such as battery level are available?
I also received http://bit.ly/2EQvVPM which gives a value of 1002 and shows "Pressed one time". If I quick press twice, the message goes blank but the value still remains at 1002 as far as I can tell.
Lastly I received http://bit.ly/2C4URlK door sensors. Very nice but only stick-on, although they're so light I'm sure they'll stay put even on wood frames. All the devices are instant response so creating events to z-wave devices was a piece of cake.
They all paired with the Raspbee and of course showed up immediately in HS3. I do wish there were some english instructions that would point out how long to hold a button for pairing and how long to hold a button for reset. I have yet to see this online.
Does anyone have the Aqara hub to see if things such as battery level are available?
Comment