I am testing the PI using a Uno with an Ethernet board sitting on top and all has been working well until I restarted HS. My configuration has the 2 outputs I am using inverted to interface with a relay board (active low). I also deleted the graphic controls I don't need, so only 'ON" and 'OFF' appear on the Device Manager Screen . Both the 'inverted' status for the outputs, and the changes to the graphics were deleted on HS restart. I looked around and could not find the config file that would store these settings.
Current Date/Time: 9/28/2017 11:32:45 AM
HomeSeer Version: HS3 Standard Edition 3.0.0.368
Operating System: Microsoft Windows 10 Pro - Work Station
System Uptime: 0 Days 1 Hour 11 Minutes 22 Seconds
IP Address: 192.168.1.200
Number of Devices: 199
Number of Events: 158
Available Threads: 200
Enabled Plug-Ins
1.0.0.131: Arduino Plugin
3.1.1.24385: Blue-Iris
3.0.6.2: Insteon Thermostat
3.0.6.0: Insteon
1.0.0.5: Restart
3.1.0.2: Sonos
Current Date/Time: 9/28/2017 11:32:45 AM
HomeSeer Version: HS3 Standard Edition 3.0.0.368
Operating System: Microsoft Windows 10 Pro - Work Station
System Uptime: 0 Days 1 Hour 11 Minutes 22 Seconds
IP Address: 192.168.1.200
Number of Devices: 199
Number of Events: 158
Available Threads: 200
Enabled Plug-Ins
1.0.0.131: Arduino Plugin
3.1.1.24385: Blue-Iris
3.0.6.2: Insteon Thermostat
3.0.6.0: Insteon
1.0.0.5: Restart
3.1.0.2: Sonos
Comment