disabled zones showing Comms fail
Hi,
Thanks again for writing this plugin. I have version 1.2 Hardware with version 1.5 firmware and using a Hometroller SEL. I have it basically working but am not using zones 7 and 8 and have them disabled. However both zones in the plug in show comms fail. I have tried with them enabled also and have set the number of zones to 6 in the configuration.
ocxoman
I found that if I set the number of zones to 8 in the open sprinkler config then the zones are read as disabled and the "comms fail" message does not appear. Thanks again for such a useful plugin.
Hi,
Thanks again for writing this plugin. I have version 1.2 Hardware with version 1.5 firmware and using a Hometroller SEL. I have it basically working but am not using zones 7 and 8 and have them disabled. However both zones in the plug in show comms fail. I have tried with them enabled also and have set the number of zones to 6 in the configuration.
ocxoman
I found that if I set the number of zones to 8 in the open sprinkler config then the zones are read as disabled and the "comms fail" message does not appear. Thanks again for such a useful plugin.
Comment