Hi all,
my syslog is floaded with messages from the arduino plugin:
Dec 12 11:33:06 RPi3-HS3 start_homeseer.sh[2547]: decimalSeparator = .
these messages appear 3 to 5 times per second.
If I disable the plugin then these mesages disappear, that why I think the Arduino plugin is the cause.
Is there a way to stop this? Any help appriciated.
Regards, Cor
HomeSeer Version: HS3 Standard Edition 3.0.0.368
Linux version: Linux RPi3-HS3 4.9.35-v7+ #1014 SMP Fri Jun 30 14:47:43 BST 2017 armv7l GNU/Linux System Uptime: 0 Days 0 Hours 22 Minutes 4 Seconds
IP Address: 192.168.1.20
Number of Devices: 416
Number of Events: 185
Available Threads: 398
Enabled Plug-Ins
1.0.0.142: Arduino Plugin
3.0.0.5: CM15A
0.0.0.19: DoorBird
0.0.0.35: Pushover 3P
3.0.5917.35093: UltraLog3
3.0.1.165: Z-Wave
my syslog is floaded with messages from the arduino plugin:
Dec 12 11:33:06 RPi3-HS3 start_homeseer.sh[2547]: decimalSeparator = .
these messages appear 3 to 5 times per second.
If I disable the plugin then these mesages disappear, that why I think the Arduino plugin is the cause.
Is there a way to stop this? Any help appriciated.
Regards, Cor
HomeSeer Version: HS3 Standard Edition 3.0.0.368
Linux version: Linux RPi3-HS3 4.9.35-v7+ #1014 SMP Fri Jun 30 14:47:43 BST 2017 armv7l GNU/Linux System Uptime: 0 Days 0 Hours 22 Minutes 4 Seconds
IP Address: 192.168.1.20
Number of Devices: 416
Number of Events: 185
Available Threads: 398
Enabled Plug-Ins
1.0.0.142: Arduino Plugin
3.0.0.5: CM15A
0.0.0.19: DoorBird
0.0.0.35: Pushover 3P
3.0.5917.35093: UltraLog3
3.0.1.165: Z-Wave
Comment