I just got my tax refund and stimulate the economy by buying a TruColor II.. and having a difficult time getting the plug-in to work.
I'm using a Sena ether->serial, it is set up properly and using their port monitor. I have configured the to use interface protocol ProLite and sign firmware prolite. using 1.0.70
When I send the test command to via LEDAM I see this in port monitor:
From what I have gathered this looks like it sets page Y to 'This is a test' (twice), performs a 'run page', then sends a blank message, and another run page. The problem is the sign does not do anything with this.
So I connect with their lovely software (looks like an early win95 reject app) and I see this on the monitor:
And everything works as I expect. To me it looks like LEDCAM is not sending the ctrl-M and ctrl-J, and I can not find an interface/protocol combo that sends the data in the proper format. Am I missing something?
Secondly, why use page Y over page A?
I'm using a Sena ether->serial, it is set up properly and using their port monitor. I have configured the to use interface protocol ProLite and sign firmware prolite. using 1.0.70
When I send the test command to via LEDAM I see this in port monitor:
Code:
<ID01><PY>This is a test <ID01><PY>This is a test <ID01><RP> <ID01><PY> <ID01><RPY>
So I connect with their lovely software (looks like an early win95 reject app) and I see this on the monitor:
Code:
<ID01><PY>this is a test^M^J (closes the COM port and reopens) <ID01><RPY>^M^J
Secondly, why use page Y over page A?
Comment