On my Mac OS X 10.9 server, lsusb doesn't do anything... (it's not a valid command). :-(
None the less if you have the USB port configured to the Z-Wave device then when you go to the controller status you will see the right stuff (firmware, devices et al in the configuration pieces of the Z-Wave device (whatever it may be). So you could "guess".
I am also guessing right now you are running HS3 in iOS and not in parallels or concurrent with HS3 running in Windows/parallels eh?
Both accessing hardware would cause discontent on your MAC.
IE: the status under plugins will show an error of it not connecting. You cannot break anything as its just a computer and software.
As you are still playing with HS3; it would behoove you to remove all of the devices / events based on said devices that have been created and start from scratch.
Just last night dealt with a similiar issue and I couldn't tell whether the old Z-wave devices would work with a updated Z-Wave plugin / Aeon stick controller on a Homestroller for a HS3 user that I was helping.
The Z-Wave DB in HS3 was showing up as corrupt with the newer HS3 Z-Wave plugin. I kept trying older Z-Wave DB's and they just didn't work. Rather here then I just went to reading the Z-wave controller and using the new devices that it created (well not even sure that those would work).
This issue cropped up on the day before this Homeseer user was going on a vacation which is not really a good time for this to happen.
Comment