View Single Post
  #5  
Old May 7th, 2017, 06:07 PM
Kirkla79 Kirkla79 is offline
Viewer
 
Join Date: May 2017
Location: TN
Posts: 4
I have downloaded HS3 and am using the smartstick+ for zwave.

I am running into issues with trying to remove/add devices.

I am unable to get many of my devices seen by the smartstick.

About half of my modules nor most of my older zwave outlets or switches are being found. These are all powered devices (have not tried any battery devices yet).

I also at this point have zwave devices added for every room so I would think I have sufficient mesh network to allow for easier finding of devices.

I have ordered an USB extension cable hoping for better reception.

Is there an issue with Homeseer and older zwave devices? They are older Intermatic zwave outlets and a couple of switches.
Reply With Quote