I have run z-seer+ on my cabin network and it only polls from one Z-Net device, after trying to disabled and disconnect that device, it just errors out. I read that it can only read from one controller, but not only is it not switching to the other controller but the controller it is reading from only gives me 1 device when I know there are 4 devices
Here are the errors I get when opening z-seer+, these devices are on the controller that I can't connect to using z-seer+:
Skipping device Cabin GarageCabin Garage Camera Appliance Module since its Z-Wave node ID is 0
Skipping device Z-WaveAeon Labs Repeater Slave since its Z-Wave node ID is 0
Skipping device BunkhouseVision Sec Notification Sensor since its Z-Wave node ID is 0
Skipping device Z-WaveVision Sec Notification Sensor since its Z-Wave node ID is 0
Skipping device Z-WaveAeon Labs Repeater Slave 12 since its Z-Wave node ID is 0
Here are the errors I get when opening z-seer+, these devices are on the controller that I can't connect to using z-seer+:
Skipping device Cabin GarageCabin Garage Camera Appliance Module since its Z-Wave node ID is 0
Skipping device Z-WaveAeon Labs Repeater Slave since its Z-Wave node ID is 0
Skipping device BunkhouseVision Sec Notification Sensor since its Z-Wave node ID is 0
Skipping device Z-WaveVision Sec Notification Sensor since its Z-Wave node ID is 0
Skipping device Z-WaveAeon Labs Repeater Slave 12 since its Z-Wave node ID is 0
Comment