I tried to install the new weathercom files to eliminate the earlier error messages from when the logic was updated, but now I am getting some weird error messages in the logs.. Probably something I did wrong, but unsure how to fix it.. (see below).. also, when I try to go to my HS Setup page (http://192.168.1.26:81/conf
-
-
This means the scriptingReferences has not been setup yet.
Check out this thread:
http://forums.homeseer.com/showthread.php?t=153232 <!-- / message --><!-- sig -->--
Jeff Farmer
HS 3, HSPhone
My HS3 Plugins: CFHSExtras, Random, Restart, Tracker, WeatherXML, PanaBluRay
Other Plugins In Use: APCUPSD, BLOnkyo, Device History, EasyTrigger, HSTouch Server, PHLocation2, Pushover, RFXCom, UltraGCIR3, UltraMon3, UltraPioneerAVR3, X10, Z-Wave
Hardware: GoControl Irrigation Controler, Schlage Lever Lock, Schlage Deadbolt, Way2Call Hi-Phone, RFXCom RFXrec433 Receiver, WGL 800, TI-103, Z-Net, Pioneer 1120, Pioneer 1021, Pioneer LX302, Panasonic BDT-110, Panasonic BDT-210 x2 -
Make sure it is in the [Settings] section:
Putting it at the end of the file most likely puts it in a different section.--
Jeff Farmer
HS 3, HSPhone
My HS3 Plugins: CFHSExtras, Random, Restart, Tracker, WeatherXML, PanaBluRay
Other Plugins In Use: APCUPSD, BLOnkyo, Device History, EasyTrigger, HSTouch Server, PHLocation2, Pushover, RFXCom, UltraGCIR3, UltraMon3, UltraPioneerAVR3, X10, Z-Wave
Hardware: GoControl Irrigation Controler, Schlage Lever Lock, Schlage Deadbolt, Way2Call Hi-Phone, RFXCom RFXrec433 Receiver, WGL 800, TI-103, Z-Net, Pioneer 1120, Pioneer 1021, Pioneer LX302, Panasonic BDT-110, Panasonic BDT-210 x2Comment
-
Jeff,
Youre too fast.. just after I sent the last msg i looked again at the file and saw that I had put it in the "display" section - duh. I deleted my msg to you only to find that you had already replied.. now thats top service.. thanks!!!!Comment
Comment