I am trying to setup a script to send me an email at 11pm if I have left the light in my office on. I have broken this into two scripts, a time based script that triggers the light level test.
The light level test is a manual script with conditions. I have a device condition on the HSM100 light sensor value. The problem is the script always runs the event regardless of the light level... i.e. (Office HSM Luminance value is in the range 7000...10000). This is true if the sensor is returning 0, 3000 (i.e. 30%), or (10000) 100%.
Is there a trick to formatting the range parameter? I have tried 70...100, 7000...100000, 70:100, 7000:10000 nothing seems to work correctly.
I am testing by clicking the run button (I have tried on the light test script and on the time script) and it seems to always perform the action.
Thanks
The light level test is a manual script with conditions. I have a device condition on the HSM100 light sensor value. The problem is the script always runs the event regardless of the light level... i.e. (Office HSM Luminance value is in the range 7000...10000). This is true if the sensor is returning 0, 3000 (i.e. 30%), or (10000) 100%.
Is there a trick to formatting the range parameter? I have tried 70...100, 7000...100000, 70:100, 7000:10000 nothing seems to work correctly.
I am testing by clicking the run button (I have tried on the light test script and on the time script) and it seems to always perform the action.
Thanks
Comment