Setting the Setpoint in a thermostat

[kbuth]

When I set a new Setpoint in a thermostat using the Web interface tyhe log will say the new Setpoint value is added to the wake up queue but after wake up the old value is shown again.

This is a Poop / Danfors radiator mounted thermostat. Any idea?

[kbuth]

System details

Current Date/Time: 19-Sep-17 7:57:07 AM
HomeSeer Version: HS3 Pro Edition 3.0.0.357
Operating System: Microsoft Windows 10 Enterprise 2015 LTSB - Work Station
System Uptime: 5 Days 2 Hours 45 Minutes 55 Seconds
IP Address: 192.168.253.161
Number of Devices: 325
Number of Events: 75
Available Threads: 400

Enabled Plug-Ins
2.0.35.0: BLLAN
30.0.0.35: RFXCOM
1.0.0.6: Sample Plugin
1.2.2.0: SceneMaster
3.0.0.21: Sonos
3.0.1.144: Z-Wave

[mrhappy]

I don't know alot about these devices but if you search around here for Danfoss you are likely to find threads discussing these devices, I think that because they are battery devices that they will periodically wake up rather than be constantly listening (as that would just drain the batteries in no time). When they wake up HS will send the new set point to them which I think you are saying happens but they don't keep the value / device does not keep that value?

[kbuth]

You are correct!

Thank you so much Mr. Happy. The new value is queued and once it weakes the value is set but the thermostat resets it again.

I have meanwhile "played"with the Thermostat as my wife turned Mrs. UNhappy . It SEEMS that corrected the problem, but I remeber it did work initially as well.

Battery operated decices are a pain though

Keeping my fingers crossed.