Z-NET Release Notes
Changes to Z-NET version 1.0.25:
* Added support for Sonoff Zigbee Interface. Updated restart landing pages.
Changes to Z-NET version 1.0.23:
* Added support to use the UZB Z-Wave interface instead of the built-in interface. This is mainly for use with the EU version of our Z-NET.
Changes to Z-NET version 1.0.22:
* Changes to support Z-NET V2
Changes to Z-NET version 1.0.20:
* Added a timeout to the network connection, if no data is received for 60 seconds, the connection is terminated which forces the Z-Wave plugin to re-connect.
Changes to Z-NET version 1.0.17:
* Fixed SSID not being saved if it contained $ characters (password also). Affects WIFI settings only.
* Added ability to reset the network settings to their defaults by pressing the "r" key and ENTER on an attached USB keyboard when the LED turns YELLOW for 5 seconds.
* Fixed settings getting lost if unit was power cycled immediately after the update was applied. See important note below.
Changes to Z-NET version 1.0.15:
* Fixed unit going back to DHCP if no network was available during startup
To update a Z-NET use find.homeseer.com to find your unit then click on the IP address to display the configuration page, then click the Update button.
IMPORTANT: There is a known issue with versions prior to 1.0.17, DO NOT power cycle the unit after you perform an update. If a power cycle is done immediately after an update the settings will not be saved properly and the unit will not boot. Wait at least 10 minutes before cycling power which is plenty of time for the settings to be saved.
Changes to Z-NET version 1.0.25:
* Added support for Sonoff Zigbee Interface. Updated restart landing pages.
Changes to Z-NET version 1.0.23:
* Added support to use the UZB Z-Wave interface instead of the built-in interface. This is mainly for use with the EU version of our Z-NET.
Changes to Z-NET version 1.0.22:
* Changes to support Z-NET V2
Changes to Z-NET version 1.0.20:
* Added a timeout to the network connection, if no data is received for 60 seconds, the connection is terminated which forces the Z-Wave plugin to re-connect.
Changes to Z-NET version 1.0.17:
* Fixed SSID not being saved if it contained $ characters (password also). Affects WIFI settings only.
* Added ability to reset the network settings to their defaults by pressing the "r" key and ENTER on an attached USB keyboard when the LED turns YELLOW for 5 seconds.
* Fixed settings getting lost if unit was power cycled immediately after the update was applied. See important note below.
Changes to Z-NET version 1.0.15:
* Fixed unit going back to DHCP if no network was available during startup
To update a Z-NET use find.homeseer.com to find your unit then click on the IP address to display the configuration page, then click the Update button.
IMPORTANT: There is a known issue with versions prior to 1.0.17, DO NOT power cycle the unit after you perform an update. If a power cycle is done immediately after an update the settings will not be saved properly and the unit will not boot. Wait at least 10 minutes before cycling power which is plenty of time for the settings to be saved.
Comment