Mark,
I'm experiencing some odd behavior.
I have two Events, one triggered by X10 code L4 ON and the other by L4 OFF. They seem to work normally when receiving the L4 commands. However, I also have a lamp on code L14. When I send an L14 ON command, my L4 ON event runs. Likewise, sending an L14 OFF triggers the L4 OFF event.
Can you see if you can replicate this issue?
Mike
I'm experiencing some odd behavior.
I have two Events, one triggered by X10 code L4 ON and the other by L4 OFF. They seem to work normally when receiving the L4 commands. However, I also have a lamp on code L14. When I send an L14 ON command, my L4 ON event runs. Likewise, sending an L14 OFF triggers the L4 OFF event.
Can you see if you can replicate this issue?
Mike
Comment