My X10 devices were controlled using a CM11, which died yesterday. As a stopgap I found an old TM12, set it to house code C and added C3 and C7 as output devices on my RFXtrx433e. C3 is switched by an RFXCOM plugin thermostat, C7 by an Arduino plugin 1-wire temperature sensor. C3 is switching fine, but every time C7 switches, the TM12 switches too.
What have I done wrong? I’ve checked and double-checked everything I can think of... at one point I selected the TM12 under ‘linked devices’ for C7 - I think this is when it started happening, but I have deselected it now to no avail. I have completely removed the TM12 from the devices list, but it is still switching with C7.
What have I done wrong? I’ve checked and double-checked everything I can think of... at one point I selected the TM12 under ‘linked devices’ for C7 - I think this is when it started happening, but I have deselected it now to no avail. I have completely removed the TM12 from the devices list, but it is still switching with C7.
Comment