Announcement
Collapse
No announcement yet.
How to set up RFXCOM for use with W800 RF (32Bit) Controller
Collapse
X
-
Does the receiver start properly? Check the log settings. Does it show anything unusual? You also need to activate the house codes you want to use (see section 4 and 4.1 of the manual) and then manually create the devices and set the house and device code in the configuration tab. Don't change anything in the X10 tab.
Sent from my Phone using TapatalkHS 4.2.8.0: 2134 Devices 1252 Events
Z-Wave 3.0.10.0: 133 Nodes on one Z-Net
Comment
-
To see communication with the receiver in the HS log you can enable Debug level 1 for the Receivers on the RFXCOM - General config page.
The W800 can be added on the RFXCOM - Receivers config page.
The W800 should not be in use by another program or plug-in to have the COM visible in the selection box.
Check only the X10 and 32 bits receiver boxes:
Comment
Comment