I'm a bit confused and looking for some guidance/help.
I have a virtual device I created that I want to update when any motion sensor in my basement activates. When all motion sensors clear, I want to clear the device.
I created a new, status only device, with two values: 0 for No Motion, and 100 for Motion.
When I created an event, I was a bit suprised to find that there is no way to update the status of a status only device. You can only control a control device.
I got around this by using a script command.
Am I missing something?
I have a virtual device I created that I want to update when any motion sensor in my basement activates. When all motion sensors clear, I want to clear the device.
I created a new, status only device, with two values: 0 for No Motion, and 100 for Motion.
When I created an event, I was a bit suprised to find that there is no way to update the status of a status only device. You can only control a control device.
I got around this by using a script command.
Am I missing something?
Comment