Converting over from SmartThings...gosh is the response time so much better with HS.
One thing I am missing from WebCore with SmartThings seems to be the ability to query a device for it current state...store that data...make a temporary change and then restore the device to it's original state.
For instance...
If someone comes on the front porch and doesn't ring the doorbell (usually FedEx or UPS) I want three different sets of lights to flash inside. When that sequence completes...I don't want them to be turned either on or off...(and end up in the dark for example) I want them to restore to whatever state they were in before the event to flash the lights ran.
Is there a plug in that can do this...if not...any steps to get where I want to be?
THANKS!
Tom
One thing I am missing from WebCore with SmartThings seems to be the ability to query a device for it current state...store that data...make a temporary change and then restore the device to it's original state.
For instance...
If someone comes on the front porch and doesn't ring the doorbell (usually FedEx or UPS) I want three different sets of lights to flash inside. When that sequence completes...I don't want them to be turned either on or off...(and end up in the dark for example) I want them to restore to whatever state they were in before the event to flash the lights ran.
Is there a plug in that can do this...if not...any steps to get where I want to be?
THANKS!
Tom
Comment