donmor,
Config:
Current Date/Time: 6/4/2017 9:32:20 AM
HomeSeer Version: HS3 Pro Edition 3.0.0.318
Operating System: Microsoft Windows Embedded Standard - Work Station
System Uptime: 0 Days 19 Hours 13 Minutes 19 Seconds
IP Address: 10.0.1.2
Number of Devices: 177
Number of Events: 34
Available Threads: 200
Enabled Plug-Ins
1.1.7.0: Honeywell WiFi Thermostat
3.0.0.83: LutronCaseta
Power outages occur every month or so in my area, especially with Spring storms. We had one on this past Friday evening, 2 Jun. The HomeSeer system came back up as usual, except Telnet did not connect for any of my three Smart Bridge Pro 2 units. Thus no Lutron control was possible. After trying a series of things I noticed that the IP address as indicated in the Homeseer log was NOT correct. I went to the Plug Ins>Lutron Caseta>Config and noticed two things, the IP addresses were blank for each Smart Bridge and none of them were enabled. I enabled all three and put in the correct IP address and all is well.
Question: Can I expect this from now on with all power fail conditions or was this some sort of anomaly? Is there something I can do to prevent the IP addresses from "disappearing"? Do they have to be re-enabled each time?
NOTE: In the middle of trouble shooting I went ahead and updated to the latest Plug-in. I think I was at 3.0.0.80 before this latest update.
Justin in Dallas
Config:
Current Date/Time: 6/4/2017 9:32:20 AM
HomeSeer Version: HS3 Pro Edition 3.0.0.318
Operating System: Microsoft Windows Embedded Standard - Work Station
System Uptime: 0 Days 19 Hours 13 Minutes 19 Seconds
IP Address: 10.0.1.2
Number of Devices: 177
Number of Events: 34
Available Threads: 200
Enabled Plug-Ins
1.1.7.0: Honeywell WiFi Thermostat
3.0.0.83: LutronCaseta
Power outages occur every month or so in my area, especially with Spring storms. We had one on this past Friday evening, 2 Jun. The HomeSeer system came back up as usual, except Telnet did not connect for any of my three Smart Bridge Pro 2 units. Thus no Lutron control was possible. After trying a series of things I noticed that the IP address as indicated in the Homeseer log was NOT correct. I went to the Plug Ins>Lutron Caseta>Config and noticed two things, the IP addresses were blank for each Smart Bridge and none of them were enabled. I enabled all three and put in the correct IP address and all is well.
Question: Can I expect this from now on with all power fail conditions or was this some sort of anomaly? Is there something I can do to prevent the IP addresses from "disappearing"? Do they have to be re-enabled each time?
NOTE: In the middle of trouble shooting I went ahead and updated to the latest Plug-in. I think I was at 3.0.0.80 before this latest update.
Justin in Dallas
Comment