Announcement

Collapse
No announcement yet.

GE smart motion sensor-not working with Homeseer

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    GE smart motion sensor-not working with Homeseer

    Just purchased several of the GE smart motion sensors(zw6302)for my basement lighting. For some reason I keep getting error messages when i try to add. Are these motions not compatible with Homeseer?


    Current Date/Time: 11/28/2017 8:37:13 PM
    HomeSeer Version: HS3 Standard Edition 3.0.0.368
    Linux version: Linux hometrollerSEL 3.16.0-031600-generic #201408031935 SMP Sun Aug 3 23:56:17 UTC 2014 i686 i686 i686 GNU/Linux System Uptime: 2 Days 2 Hours 43 Minutes 24 Seconds
    IP Address:
    Number of Devices: 30
    Number of Events: 5
    Available Threads: 199

    Enabled Plug-Ins
    3.0.1.130: Z-Wave

    #2
    What error are you receiving?
    💁‍♂️ Support & Customer Service 🙋‍♂️ Sales Questions 🛒 Shop HomeSeer Products

    Comment


      #3
      Todd- Did you ever get these motion sensors working? I'm able to add them to HS3 but it doesn't seem to add the motion detection "Home Security" component so motion events can't be created.

      Comment


        #4
        I resolved my issue by changing the "Alternate inclusion option" to the default of one flash after holding down the "Set" button for 3 sec. Details are in the sensor manual.

        "Alternate inclusion options
        If the sensor has difficulty connecting to your
        controller, refer to the following table for alternate
        inclusion options."

        Comment

        Working...
        X