auto lo
iface lo inet loopback
iface eth0 inet static
address 192.168.0.200
netmask 255.255.255.0
gateway 192.168.0.1
allow-hotplug wlan0
iface wlan0 inet manual
wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf
network 0.0.0.0
address 0.0.0.0
netmask 255.255.255.0
gateway 192.168.1.1
iface default inet static
-----------------------------
Would this be correct for static at 192.168.0.200
Changed DHCP to "static", 2 places
The objective is to have the ZEE S2 on the same IP when it is attached to the network over ethernet or the WiFi dongle. Now I get two different IPs depending on the attachment.
When would one change the wlan0 settings?
Thanks
Al
iface lo inet loopback
iface eth0 inet static
address 192.168.0.200
netmask 255.255.255.0
gateway 192.168.0.1
allow-hotplug wlan0
iface wlan0 inet manual
wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf
network 0.0.0.0
address 0.0.0.0
netmask 255.255.255.0
gateway 192.168.1.1
iface default inet static
-----------------------------
Would this be correct for static at 192.168.0.200
Changed DHCP to "static", 2 places
The objective is to have the ZEE S2 on the same IP when it is attached to the network over ethernet or the WiFi dongle. Now I get two different IPs depending on the attachment.
When would one change the wlan0 settings?
Thanks
Al
Comment