Z-wave lock not showing in HS3 iOS app?

[mike2016]

Is there a specific way to make Z-wave devices show in HS3 app or Imperial Home app?

My one and only Z-wave device - a schlage lock, was finally added to HS3 today. I can control it from the web interface, but it's not showing in the iPhone app or the Imperial home app.

all my other devices are Insteon which work just fine in either apps.

Thanks guys

[integlikewhoa]

Is there a specific way to make Z-wave devices show in HS3 app or Imperial Home app?

My one and only Z-wave device - a schlage lock, was finally added to HS3 today. I can control it from the web interface, but it's not showing in the iPhone app or the Imperial home app.

all my other devices are Insteon which work just fine in either apps.

Thanks guys

This has been anwsered many times in the right forum. The imperihome section of the forum.

Click on the lock in the HS3 web UI.
go to the status graphics tab
Make sure the "Control Use:" drop down is set for door unlock on the unlock and door lock on the lock.

then refresh everything and it will show up.