HI,
I have migrated to HS3, including EZFlora and everything works fine (almost).
I can run my programs via event actions.
I can manually start/stop any valve directly from the device control screen.
I can run any valve or combination of valves directly from a timed event (in case I need a temporary schedule not covered by the programs).
The issue is with directly controlling a valve through an event which is initiated by the remote I/O link. A button on the I/O link sets the valve to ON. Pressing the same button again sets the valve to OFF. The log shows device control setting the valve on, but no response from the valve. What is really strange is that 2 of the 4 valves work fine using the i/O link. Strange and confusing.!!
any thoughts?
HS3 3.0.0.96
EZFlora 2.0.0.1
Insteon 3.0.4.4
I have migrated to HS3, including EZFlora and everything works fine (almost).
I can run my programs via event actions.
I can manually start/stop any valve directly from the device control screen.
I can run any valve or combination of valves directly from a timed event (in case I need a temporary schedule not covered by the programs).
The issue is with directly controlling a valve through an event which is initiated by the remote I/O link. A button on the I/O link sets the valve to ON. Pressing the same button again sets the valve to OFF. The log shows device control setting the valve on, but no response from the valve. What is really strange is that 2 of the 4 valves work fine using the i/O link. Strange and confusing.!!
any thoughts?
HS3 3.0.0.96
EZFlora 2.0.0.1
Insteon 3.0.4.4
Comment