Hi
I am trying to read some values over modbus using this plugin. I have tried following the read me but the device I am reading from has a table as shown in the attached picture. Not sure which values I am to enter in the register adress as the manual says xxx-xxx and the input field doesn't allow "-" to be typed in the registed adress field. I know the communication is ok as I have used the manufacturers software that also uses modbus to communicate and used the same settings and slave ID.
Here is the direct link to the user manual:
http://109.238.53.160//Publication/D...9300022_UK.pdf
I am trying to read some values over modbus using this plugin. I have tried following the read me but the device I am reading from has a table as shown in the attached picture. Not sure which values I am to enter in the register adress as the manual says xxx-xxx and the input field doesn't allow "-" to be typed in the registed adress field. I know the communication is ok as I have used the manufacturers software that also uses modbus to communicate and used the same settings and slave ID.
Here is the direct link to the user manual:
http://109.238.53.160//Publication/D...9300022_UK.pdf
Comment