Mark,
After 4 weeks of efforts yesterday I had several switches, dimmers, motion switches about 22 devices, installed with events working and was very pleased with the Plug In I had 24 days left on the trial...... I was so please with the Plug-IN I purchased a License and registered it late last night.... This is where something went South..
All of the time events quite working. All of the motion triggered events quite working.
I found this error message in the Insteon configuration page
You do not have the I/O interface enabled in HomeSeer
I searched the forum and followed your advise set COM3 (capital letters)
http://board.homeseer.com/showthread...er#post1154551
I got the plug-in to recognize the 2413U device.
However to my surprise all of the Insteon devices are missing and do not show up as configured devices......
Thoughts and advise or recovery or do I have to start all over....
After 4 weeks of efforts yesterday I had several switches, dimmers, motion switches about 22 devices, installed with events working and was very pleased with the Plug In I had 24 days left on the trial...... I was so please with the Plug-IN I purchased a License and registered it late last night.... This is where something went South..
All of the time events quite working. All of the motion triggered events quite working.
I found this error message in the Insteon configuration page
You do not have the I/O interface enabled in HomeSeer
I searched the forum and followed your advise set COM3 (capital letters)
http://board.homeseer.com/showthread...er#post1154551
I got the plug-in to recognize the 2413U device.
However to my surprise all of the Insteon devices are missing and do not show up as configured devices......
Thoughts and advise or recovery or do I have to start all over....
Comment