With the S5 firmware on this device it now reports Watts and wall button presses instantly. So far so good. But kWH are reported without any pattern from what I can see. I have set polling to once an hour but this doesn't seem to help.
I have the default settings (only changed to mono stable buttons) and associations. I can't see in the manual that there are any settings for kWH but I see "meter" mentioned together with associations. Though, I'm not sure how I could use this.
My associations are:
- Group 1 to HomeSeer Endpoint 1
- Group 2 to HomeSeer Endpoint 2
Any thoughts?
I have the default settings (only changed to mono stable buttons) and associations. I can't see in the manual that there are any settings for kWH but I see "meter" mentioned together with associations. Though, I'm not sure how I could use this.
My associations are:
- Group 1 to HomeSeer Endpoint 1
- Group 2 to HomeSeer Endpoint 2
Any thoughts?
Comment