Firmware Supported
Ultra,
Do you know of any firmware issues? I have a very old GC-100 12 and 2 of the GC-IRLs. I tried the plug-in and it found the GC-100 no problem, was able to connect Serial 1 and Serial 2 to the GC-IRLs, but I tried setting up an IR trigger using each of the IRLs and every time it got stuck repeating that I needed to send the 3 IR signals one more time to confirm that it is consistent... But it kept asking after multiple iterations of 3 button presses plus Create.
Could the hardware be too old?
I also have a bunch of these in the log:
No response/improper response from SERIAL [192.168.1.16] to command 'id'
Thanks
Do you know of any firmware issues? I have a very old GC-100 12 and 2 of the GC-IRLs. I tried the plug-in and it found the GC-100 no problem, was able to connect Serial 1 and Serial 2 to the GC-IRLs, but I tried setting up an IR trigger using each of the IRLs and every time it got stuck repeating that I needed to send the 3 IR signals one more time to confirm that it is consistent... But it kept asking after multiple iterations of 3 button presses plus Create.
Could the hardware be too old?
I also have a bunch of these in the log:
No response/improper response from SERIAL [192.168.1.16] to command 'id'
Thanks