One of my locks says unknown status and hs3 is saying it can't communicate with the lock. It was fine yesterday.
I tried going to the device z wave tab and pressing rescan and I also tried running optimize. It says it can't reach it.
But on node config it says it's recognize about 50 neighbors.
It's a schlage connect.
What should I try next? It's a little disconcerting my door lock just started doing this...
I tried going to the device z wave tab and pressing rescan and I also tried running optimize. It says it can't reach it.
But on node config it says it's recognize about 50 neighbors.
It's a schlage connect.
What should I try next? It's a little disconcerting my door lock just started doing this...
Comment