I have two CT100 units. One is in direct connection with the ZNET and the other goes through a repeater. However, both experience the same behavior. Sometimes I will change the temp through HS3Touch and the setting won't change for up to a minute. Sometimes it will change right away, but the Operating State won't change for minutes. The associations are setup correctly in the Z-Wave tab, so why are they lagging?
I would love for these to work right, but I can't say it's ever been 100% since day one. I am seriously considering ditching them and replacing with Arduinos.
I would love for these to work right, but I can't say it's ever been 100% since day one. I am seriously considering ditching them and replacing with Arduinos.
Comment