I haven't used BLSec in a looooong time, during two moves across the state. Today I tried to fire it up and am having troubles.
I deleted many of the old devices from BLSec since they weren't accurate or in-use now. I added some DS10A devices that are in place. After setting them as Perimeter devices, and arming the panel in Perimeter mode, I can't get them to trigger a fault! I see the device change in the HS log, but BLSec acts like it sees nothing of the device change.
Is it possible some update to HS or elsewhere has corrupted a piece of my BLSec install? Not sure where/what else to look at. I know this definitely worked in the past.
Thanks
Darrel
I deleted many of the old devices from BLSec since they weren't accurate or in-use now. I added some DS10A devices that are in place. After setting them as Perimeter devices, and arming the panel in Perimeter mode, I can't get them to trigger a fault! I see the device change in the HS log, but BLSec acts like it sees nothing of the device change.
Is it possible some update to HS or elsewhere has corrupted a piece of my BLSec install? Not sure where/what else to look at. I know this definitely worked in the past.
Thanks
Darrel
Comment