New house construction using PEX tubing for in-basement-floor and under-subfloor hydronic radiant heat. There are four zones, meaning four pumps, four temp sensors, and a four-zone thermostat. I want to use in-floor sensors to monitor floor temp (recommend with hydronic radiant), have a wall-mount thermostat, and be able to override or change wall-mount using HS. (I'm not yet a HS user, but plan to purchase. Construction phase is open studs, rough-in wiring, getting ready for CAT5e. I welcome any suggestions on thermostats, wiring, etc. I will need to be able to control the heat before HS gets installed and running. Thanks. -Jack
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment