Version 3.0.6.0 is in the Updater. This version is Linux and Windows compatible. This is a Release version of the last beta 3.0.5.88. No additional changes/features. Homeseer 3.0.0.152 is required for this version for the best experience with the plugin during programming.
Please post issues with this Release to this thread.
This version can make backup copies of the insteon.ini to help avoid losing your configuration if HS3 crashes. You must setup an event using the new trigger and action provided.
Please see the Revision History for details: http://forums.homeseer.com/showthread.php?t=138815
Important
1. Make a backup of your insteon.ini before you do this in case something goes wrong. You can revert the ini and homeseer database and restart HS and try again
2. You will need to add RecreateDevices=1 to the [config] section of the insteon.ini to update the hs device definitions related to HS control. A Restart is required. This is a one time fix.
To install:
Please install from the Updater
Linux Info:
Use the following for the Port name:
/dev/ttyS0 is COM1
/dev/ttyS1 is COM2
/dev/ttyUSB0 is USB
Do not attempt to set Port=USB in the insteon.ini. This is not supported on Linux.
The Linux version also supports the Hub.
Please post issues with this Release to this thread.
This version can make backup copies of the insteon.ini to help avoid losing your configuration if HS3 crashes. You must setup an event using the new trigger and action provided.
Please see the Revision History for details: http://forums.homeseer.com/showthread.php?t=138815
Important
1. Make a backup of your insteon.ini before you do this in case something goes wrong. You can revert the ini and homeseer database and restart HS and try again
2. You will need to add RecreateDevices=1 to the [config] section of the insteon.ini to update the hs device definitions related to HS control. A Restart is required. This is a one time fix.
To install:
Please install from the Updater
Linux Info:
Use the following for the Port name:
/dev/ttyS0 is COM1
/dev/ttyS1 is COM2
/dev/ttyUSB0 is USB
Do not attempt to set Port=USB in the insteon.ini. This is not supported on Linux.
The Linux version also supports the Hub.
Comment