Hi,
I got a question regarding the behavior of a fibaro zwave relay.
S1 would be connected to an existing electronic circuit for controlling my garden lights (so it will be configured as a bistable switch). O1 would go the garden lights.
O2 would go to the same lights as well. That would act as an override for HS for when S1 would go the off state. This way I hope to prevent a short on-off-on scenario.
But what happens when HS turns off O1 and O2 when S1 was on and goes to off? Will that turn on the lights again?
Best regards,
Kriz
Verstuurd vanaf mijn Nexus 7 met Tapatalk
I got a question regarding the behavior of a fibaro zwave relay.
S1 would be connected to an existing electronic circuit for controlling my garden lights (so it will be configured as a bistable switch). O1 would go the garden lights.
O2 would go to the same lights as well. That would act as an override for HS for when S1 would go the off state. This way I hope to prevent a short on-off-on scenario.
But what happens when HS turns off O1 and O2 when S1 was on and goes to off? Will that turn on the lights again?
Best regards,
Kriz
Verstuurd vanaf mijn Nexus 7 met Tapatalk
Comment