Yes, I see that Humidity graph is available thru a drop-down menu.
As of reading electrical current I use a board that Mitch (MidonDesign) sent me back in 2010. He used a spare board and soldered a couple components there and I placed the board inside of the TEMP08.
The board is connected to the a split-core 3110 sensor that monitors status of my mini-split AC and I have ventilation events based on its reading.
I had to install an additional 1-wire jack on TEMP08 (seen on the picture with a "Clarity" label on it) and in addition to standard "GND", "DQ" and "+5V" wires I added a "+12V" (for Hobbyboards Humindity sensor) and two wires for current 3110 sensor - total I use 6 wires out of 8 available in an Ethernet cable.
As of reading electrical current I use a board that Mitch (MidonDesign) sent me back in 2010. He used a spare board and soldered a couple components there and I placed the board inside of the TEMP08.
The board is connected to the a split-core 3110 sensor that monitors status of my mini-split AC and I have ventilation events based on its reading.
I had to install an additional 1-wire jack on TEMP08 (seen on the picture with a "Clarity" label on it) and in addition to standard "GND", "DQ" and "+5V" wires I added a "+12V" (for Hobbyboards Humindity sensor) and two wires for current 3110 sensor - total I use 6 wires out of 8 available in an Ethernet cable.
Comment