Go Back   HomeSeer Message Board > Security Systems Plug-ins > Security System Discussion > HomeSeer DSC Plug-in

HomeSeer DSC Plug-in HomeSeer DSC plug-in for Power Series security panels

Thread Tools Display Modes
Old October 26th, 2017, 09:36 PM
Don J Don J is offline
Join Date: Oct 2017
Location: New York
Posts: 3
DSC pgm 1864

I'm trying to use 2 pgms to run different events so when I set the alarm is stay mode at the keypad it will turn some of the lights to 20%. Away mode all the lights off. Any suggestions would be greatly appreciated

So Far I set section 009 to 18 for stay mode pgm1
then 17 for away mode pgm2 this will give me 13.5 volts for 5 seconds (the time can be adjusted in section 170) on the desired pgm
a relay to turn these into a dry contacts is easily done
I only need a recommended analog input that will run an event

Last edited by Don J; October 27th, 2017 at 08:58 PM.
Reply With Quote


dsc pgm

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
DSC 1864 with HS3 and monitoring via Envisalink? cheeryfool Security System Discussion 5 October 11th, 2017 02:46 AM
DIY replace old Brinks/ADT with DSC 1864 mocavo67 Security System Discussion 2 May 15th, 2015 11:05 PM
DSC 1864 plus? hunter69 Security System Discussion 3 October 13th, 2014 09:44 AM
DSC 1864 and IT-100 problems Ag99JYD Security System Discussion 5 April 19th, 2014 04:22 PM

All times are GMT -4. The time now is 07:22 PM.

Copyright HomeSeer Technologies, LLC