Hi
I'm in the process of troubleshooting some "Too long wait for Answer to command..." issues, which is probably due to incorrect cabling/loose connectors/bad module; and I was testing the Signal and Noise strength tester in the PLCBUS tools plugin on my modules, one by one... and I thought it would be cool if it can be run automatically for all the addresses in a house code.
Maybe just add an 'ALL' option in the 1 to 16 drop down menu for the DeviceCode? So 1-16 + ALL at the very bottom?
Even better if we can run a per-HouseCode health-check by running both signal and noise test on each devices in a HouseCode and display the result in a table
I'm in the process of troubleshooting some "Too long wait for Answer to command..." issues, which is probably due to incorrect cabling/loose connectors/bad module; and I was testing the Signal and Noise strength tester in the PLCBUS tools plugin on my modules, one by one... and I thought it would be cool if it can be run automatically for all the addresses in a house code.
Maybe just add an 'ALL' option in the 1 to 16 drop down menu for the DeviceCode? So 1-16 + ALL at the very bottom?
Even better if we can run a per-HouseCode health-check by running both signal and noise test on each devices in a HouseCode and display the result in a table
Comment