Hi All,
I set up Alexa routines to run events.
For example Alexa, Shades Down.
She then turns off a Homeseer device. When that device is turned off, all my Shade events run.
It was working just fine. Now when I say Shades Down, Alexa runs one of the other routines(actually a different device connected to a Routine changes state). I am not sure how this got crossed up and can't fine a correlation between the unit supposed to go off and the one that actually is. All the devices in Homeseer match the the OmniPro II unit location. None of these devices is in a Room spot on the OmniPro II.
I have checked for new devices, restarted Homeseer, disabled and enabled each device, as well as the Homeseer plug in. I have tried to redo the routine as well but no success.
I did notice a new Homeseer Skill, Homeseer Smarthome.
Now I have that one, Homeseer Home Automation skill and the basic Homeseer skill enabled.
Any suggestions what could have gone off track?
Thanks,
Jason
I set up Alexa routines to run events.
For example Alexa, Shades Down.
She then turns off a Homeseer device. When that device is turned off, all my Shade events run.
It was working just fine. Now when I say Shades Down, Alexa runs one of the other routines(actually a different device connected to a Routine changes state). I am not sure how this got crossed up and can't fine a correlation between the unit supposed to go off and the one that actually is. All the devices in Homeseer match the the OmniPro II unit location. None of these devices is in a Room spot on the OmniPro II.
I have checked for new devices, restarted Homeseer, disabled and enabled each device, as well as the Homeseer plug in. I have tried to redo the routine as well but no success.
I did notice a new Homeseer Skill, Homeseer Smarthome.
Now I have that one, Homeseer Home Automation skill and the basic Homeseer skill enabled.
Any suggestions what could have gone off track?
Thanks,
Jason
Comment