I'm using Z-Troller as my primary interface and over the past couple of months been receing an increasing number of Z-Wave warnings such as "No response from device when getting level: Z-Wave Living Room Front Porch, Node: 102". I optimized my entire network and it almost seemed to make it worse because some switch devices now flash the network installation LED even though they are still able to be controlled by Home Seer. I also received Communication Errors "Failed Sending Z-Wave command to Device" on two modules. Some devices are even in the same electrical box with other modules that work correctly. The two failed devices can be controlled normally with a secondary control even though it's farther away geographically. I have a large network (over 100 nodes) so module to module communication should not be an issue. It almost appears as if Z-Troller needs an antenna. The HomeSeer CPU (and Z-Troller) is approximately 4' away from the 1st Zwave module (which incidently is one of the nodes that logs Z-Wave level warnings.
I've been working on this problem for over a week without much luck. Even tried uninstalling and re-installing devices (which resets the Network LED's OK but doesn't solve the warnings). A Network scan and optimizations brings back the flashing LED. I purchased HomeSeer Pro a few weeks ago but want to solve my problems before upgrading.
Help!!!
I've been working on this problem for over a week without much luck. Even tried uninstalling and re-installing devices (which resets the Network LED's OK but doesn't solve the warnings). A Network scan and optimizations brings back the flashing LED. I purchased HomeSeer Pro a few weeks ago but want to solve my problems before upgrading.
Help!!!
Comment