If in the Z-Wave settings I set the remote ramp rate for a dimmer to 99/1 and simply toggle the device back and forth from off to on in the Homeseer device manager, within 5 or 10 tries, I see one of two things happening:
* An off device fails to turn on, but the LED bar turns on.
* An on device fails to turn off, but the LED bar turns off.
I originally thought I was having a sporadic communications problem until I noticed the LED bar behavior. I have reproduced this on two different dimmers.
I don't seem to encounter this problem with the default 1/3 setting, only with the 99/1 setting. I didn't experiment with any other settings. I don't have any switches with older firmware, so I can't say if this bug is new or not.
Can anyone else confirm the ability to reproduce this?
* An off device fails to turn on, but the LED bar turns on.
* An on device fails to turn off, but the LED bar turns off.
I originally thought I was having a sporadic communications problem until I noticed the LED bar behavior. I have reproduced this on two different dimmers.
I don't seem to encounter this problem with the default 1/3 setting, only with the 99/1 setting. I didn't experiment with any other settings. I don't have any switches with older firmware, so I can't say if this bug is new or not.
Can anyone else confirm the ability to reproduce this?
Comment