I just installed 2 rain8net serial units, hooked up, tested with WGL config and demo softare all zones work fine. Purchased & Installed homseer plugin from updater (2.2.08). Homeseer plugin did not correctly control the 2'nd unit. No zones on 2nd unit could be controlled.
Installed 2.2.0.11 version (noted in a previous thread) and captured log (debug info on - log attached).
Noted two problems per log entries:
1 - When turning on zone 9 get "Problem Calculating Unit#." entry in log and zone does not turn on.
2 - When calculating zone numbers above 8, ie: 9..16, zone number sent in byte 3 is are not correct ( ie: 9 should be 1, 10 = 2, 11 = 3...etc)
Note - Possible additional issue (noted status did not change for zone 10 to "on" regardless of the zone not working properly...this did change in 2.2.0.8 even thoe zone didn't actually turn on.
Can you help please?
Config:
Rain8net serial (x2) Unit addresses 1 and 2
Rain8net plugin 2.2.0.11
Windows XP
Homeseer 2.2.0.66
Installed 2.2.0.11 version (noted in a previous thread) and captured log (debug info on - log attached).
Noted two problems per log entries:
1 - When turning on zone 9 get "Problem Calculating Unit#." entry in log and zone does not turn on.
2 - When calculating zone numbers above 8, ie: 9..16, zone number sent in byte 3 is are not correct ( ie: 9 should be 1, 10 = 2, 11 = 3...etc)
Note - Possible additional issue (noted status did not change for zone 10 to "on" regardless of the zone not working properly...this did change in 2.2.0.8 even thoe zone didn't actually turn on.
Can you help please?
Config:
Rain8net serial (x2) Unit addresses 1 and 2
Rain8net plugin 2.2.0.11
Windows XP
Homeseer 2.2.0.66
Comment