Announcement

Collapse
No announcement yet.

Echo Skill Device Detection

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Echo Skill Device Detection

    Are there any known issues with the UK skill that is preventing it detecting devices.
    Mine does not seem to detect any of my LightwaveRF devices, even though they arer setup and working fine in Homeseer

    #2
    Do you have the Voice command ticked under the device configuration?
    Jon

    Comment


      #3
      Do the devices have the Voice command box checked in the configuration area of there settings?
      Wade

      "I know nothing... nothing!"

      Comment


        #4
        Hi,

        Yes, I have turned voice command on for both the LightwaveRF devices and also the RFXCOM device

        Comment


          #5
          I should note.....I have tried it with and without it turned on

          Also tried the latest stable firmware and also the new beta firmware

          Comment


            #6
            You need them checked when you do your device discovery.

            Do you have any devices that were discovered?
            Wade

            "I know nothing... nothing!"

            Comment


              #7
              I had the voice command ticked during the discovery, but still didnt work.

              2 of my Z Wave devices have been found (Aeon Labs), but None of the LightwaveRF devices are being detected

              Comment


                #8
                Same issue i think - Fixed it

                Originally posted by russh View Post
                I had the voice command ticked during the discovery, but still didnt work.

                2 of my Z Wave devices have been found (Aeon Labs), but None of the LightwaveRF devices are being detected
                Hi,

                Check the "control use" drop downs under Status graphics, none of these are set using RFCom and i had the same problem so it may be the same issue.

                Cheers

                Matt

                Comment


                  #9
                  Originally posted by 10monkeys View Post
                  Hi,

                  Check the "control use" drop downs under Status graphics, none of these are set using RFCom and i had the same problem so it may be the same issue.

                  Cheers

                  Matt
                  Ha - Ignore that (it did work though), we had the same conversation elsewhere in the forum

                  Matt

                  Comment

                  Working...
                  X