I am looking for a Z-Wave parameter reference for the Go Control TBZ48 Thermostat. I have been unable to find it.
Announcement
Collapse
No announcement yet.
Go Control GC-TBZ48 Thermostat Parameters
Collapse
X
-
I sure hope this is right, because then I've given rprade an answer as opposed to always getting them from him!
https://products.z-wavealliance.org/...s/2370/configs
https://products.z-wavealliance.org/...oFilename=True
-
Originally posted by racerfern View PostI sure hope this is right, because then I've given rprade an answer as opposed to always getting them from him!
https://products.z-wavealliance.org/...s/2370/configs
https://products.z-wavealliance.org/...oFilename=TrueHS4 Pro, 4.2.19.16 Windows 10 pro, Supermicro LP Xeon
Comment
-
I just switched over to the GC-TBZ48 instead of Nest because Google's servers were not 100% reliable. Better to have the solution "in-house" I think.
That said I am getting some errors where one of my thermostats is giving "Device: Node 43 Upstairs Temperature Set to INVALID VALUE"
This resolves itself and then comes back again over and over.
Also I looked through these parameter files and can't quite figure out how to increase the frequency of updates on ambient temperature?
Comment
-
When I was allowing logging mine seemed to only send updates when the temperature changed. They are not on an interval. I have 8 of them in use and never see that error. Here is a screenshot from today. They are always correct, but only update when the temperature changes.
HS4 Pro, 4.2.19.16 Windows 10 pro, Supermicro LP Xeon
Comment
-
Thanks, I'm still not getting updates from the thermostats when the temperature changes. It's happening on all 3 of mine, so it must be something I've done wrong.
Should I set a "polling interval" on the root device or on the temperature reading itself? Are yours all on C-wire power or battery? Mine are on batteries (no c-wires) and I'm thinking maybe they try to conserve battery power by not transmitting.
did add them as non-secure nodes so I don't think that is my problem.
Comment
Comment